Slipping and Rewinding Machine

1. The slitting and rewinding machine should carry out fixed length slitting of the whole or whole raw material. For example, plastic packaging materials, packaging cartons, steel plates, film, leather, wood chips, etc. for slitting processing, must use fixed length slitting control.

2. The slitting length can be set continuously. If there is an error in the actual slitting length, it is easy to calibrate by setting parameters.

3. Slitting and rewinding machine slitting control is divided into static and dynamic slitting: it stops accurately when the set length arrives, then static slitting processing, restarts after slitting; When the set length arrives, the slitting signal is sent without stopping, and the slitting machine dynamically cuts the machining during the material movement.

Structural advantages of the slitter-winder:

The middle of the slitter-winder is equipped with a spindle for processing paper tubes, and the front end of the spindle is fixed to the base with a set of bearings. A pulley is installed in the middle of a set of bearings; a compression cylinder is installed near the base, and a support rod bearing is mounted on the upper end of the support rod of the cylinder to support the main shaft.

A main cutter shaft is mounted on the upper end of the slitter-winder, and a plurality of blades are arranged thereon and arranged in a certain gap; the main cutter shaft is also disposed at the top of the slitter-winder The support frame is provided with a supporting cylinder in the middle of the support frame.

The structural advantages of the slitter rewinding machine fill the gap in the technology of the automatic pipe cutting machine.