As everyone knows, there are some things to be aware of when using the machine, then you know < strong="">What are the precautions for using high speed slitting machine? Today, Hengguang Machinery Xiaobian has arranged for everyone, let's take a look at it!

  High-speed slitting machinePrecautions for use

01, check whether the number of joints in the product section is the same as the number of the joints. If the hot melt adhesive coating machine does not match, immediately rewind the inspection to prevent the inner joint from being mixed into the product. .

02, according to the characteristics of the semi-finished products, adjust the EPC device to ensure that the EPC photoelectric is always on the tracking line, and the end of the film is pulled at a low speed to make the film go into normal.

03, stop pressing the stop button, the hand is not allowed to touch the rewinding when unloading, so as to avoid the fingers being caught.

04, slow start, observe whether the cut film meets the quality requirements, and then slowly start to start cutting. When the machine is running, it is strictly prohibited to put your hand into the machine to avoid the back of the hand.

05, open (close) the material carrier to the appropriate width, and place the semi-finished film roll to be cut on the bracket. When loading, the hand must leave the film roll section, and do not allow two people to operate at the same time. The hand is caught by the cylinder.

06. Return the photoelectric to the center position, and ensure that the slider of the unwinding table is kept in the middle position of the guide stick.

07. Put the paper tube that meets the specifications on the receiving shaft, cut the finished product into the paper tube of the upper and lower receiving shaft according to the normal method, and start the machine at low speed to find the paper tube on the receiving shaft. The right location, mark it for the next installation. When installing the paper tube, the hand must grasp the surface of the paper tube to be scratched by the shaft.

08, all the slitted membranes are led to the reel according to the operation requirements. When the hot melt adhesive machine passes through the membrane, no blades are allowed on the machine to be scratched by the defense.

09, according to the task list, install the slitting knife holder to the appropriate position, fasten the lower knife, and then start the machine at low speed to cut the semi-finished product into the required specifications.

10. Press to turn on the power of the machine, and set the tension of the rewinding and unwinding, the number of automatic stop of the counter, and the material thickness according to the requirements on the task list, and turn on the photoelectric.