1. Correct the specifications and place the core on the inner and outer arms. Notify all personnel to leave the machine when the roller is ready to run.

    2. The second step. Place the anti-climb bar on the main console in the automatic position, open ready to run, and start the machine.

    Split Control

    When carefully monitoring and observing the effect of the slitting operation during the slitting operation, Appropriate adjustment and control of slitting speed, unwinding tension, contact pressure and arc roller, side material pulling roller, leading edge, etc.

    1. When the inner and outer ends of the winding machine stop running, use the unloading button to place the film on the prepared unloading truck, and then seal the film with sealing glue. paste.

    2. Use the release tab button to release the clip head and check that each film core leaves the core. If one end is still stuck on the core, remove the film reel manually.

    3. Make sure all the membranes leave the collet and put it in the car. Use the film button to lift the winding arm, attach the corresponding paper core, and align the film neatly on the paper core for the next cutting.

    1, when the film roll runs to the set length, the device stops automatically.

    2, during the operation of the equipment, you can stop by the parking space as needed.

    3. When you need to stop quickly, press the machine stop button for more than 2 seconds.

    4. When an emergency such as equipment or human accident occurs, stop in an emergency stop mode.

    Notes

    1, Ensure that voltage, current, and hydraulic equivalents are stable and stable before starting.

    2, all personnel must be notified to leave the device before the device is ready to run to ensure personal safety before starting the run.

    3When the slitter is running, do not touch the film roll or core with your hands to avoid personal injury caused by hand touch.

    4, do not scratch or cut the core with a knife or hard object during operation.