So you understand slitting machine? Do you know the specific procedures for using the slitting machine? Today, Hengguang Machinery Xiaobian will come to you for the popular science. If you are interested, let's take a look!

Working procedures for slitting machine

1. boot

2. Open electrical isolation switch Place it in front of the electric control cabinet. Press the EMERCENCY STOP RESET and READY TO RUN buttons. The key turns on MACHINE to RUN (on the main console) to check the voltage (380V), and the current is correct and stable.

3. Open the hydraulic system power switch (set on the main hydraulic drive frame), check the main hydraulic drive system oil level And the pressure gauge shows whether it is correct and stable.

4. Open the pneumatic shutoff valve (set on the intake pipe under the pneumatic control cabinet), check if the air pressure is correct (not Less than 6.0 bar), stable.

5. Setting Control

6. set the slitting menu according to the type, thickness, length and width of the film arranged in the cut plan.

7. From the PDF, file the corresponding BOPP film file.

8. Set the length and width of the film of the corresponding specification.

9. Select the corresponding winding station, adjust the pressure roller arm and pressure roller, install the corresponding specifications Paper core.

10. feeding, filming and filming

11. Feeding: According to the requirements of the cutting plan, according to the driving regulations, according to the actual situation, the corresponding mother roll is hoisted on the aging frame, according to the inside and outside of the corona surface The direction is placed on the slitting machine unwinding frame, and the steel core is clamped by the control button, leaving the steel core support arm and driving.

12. Film: When there is no film on the slitter, it must be filmed. Using the slitting machine through the membrane device and the function keys, one end of the original membrane is attached to the membrane chain eyelet, and the membrane button is activated to distribute the membrane along the slitting process to be evenly distributed on each roller.

13. film: When there is a film on the slitting machine, when using the vacuum joint, use the vacuum filming station, first The filming table is started to the working position, the film on the first pulling roller of the slitting machine is manually flattened and the upper vacuum pumping film is actuated, so that the film is flatly adsorbed on the filming table, the double-sided tape is attached and the tape is cut off. Excess film, flatten the film on the unwinding frame and start the lower vacuum pump to make the film flat, absorb the paper layer on the tape and flatten the adhesive film. The joints should be neat and wrinkle-free, then turn off the upper and lower vacuum pumps and connect them. The membrane table is opened to the inoperative position.