Change the specification. The paper core is on the inner middle winding arm, and the pressure roller is in the ready state. The nursing personnel will leave the machine and operate. Put the ANTI-STAICBARS on the main restraint in AUTO, READYTORUN open, and start MACHINERUN. When the inner end of the machine is restrained, use the unload button to place the film on the unloading trolley, cut the film and stick the film roll with the sealant. Use the collet release button to release the collet and check that the film core has left the core. If it is still stuck on the core, manually remove the film manually.

Make sure that the scanning film leaves the chuck on the cart and use the membrane button to buy the slitting machine blade. Mainly understand their needs. What kind of blade do we need to buy? Don't worry about the middle of the blade or buy it at a cheap price. The blade you bought is definitely not. It is right for you, the quality of that type of blade will not be very good. It will be broken over a period of time.

When buying a blade, don’t be a brand of merchandise. It is best to buy an appropriate electrical interrupt stop switch (set the equipment in front of the electric restraint cabinet), press the EMERCENCYSTOPRESET and READYTORUN buttons, the key open MACHINE to RUN (on the main console) check voltage (380V), current can be correct, bumps . Open the hydraulic system power switch (set the equipment on the main hydraulic drive frame), check whether the oil level and pressure gauge of the main hydraulic drive system are correct and bumpy.

Open the pneumatic shut-off valve (set up on the intake pipe under the pneumatic restraint cabinet), check whether the air pressure is correct (not less than 6.0 bar), bumps. According to the rules, thickness, length, width, etc. of the film that is controlled by the singularity of the sheet, the cutting and setting menu is arranged.

Lift the echoed BOPP film file from the PDF. Set the slitting machine to echo the winding length and width of the specification film. Pick up the rewinding station, dispatch the pressure roller arm and the pressure roller, and arrange the paper core that meets the specifications.

Feeding: According to the requirements of the cutting plan, according to the driving regulations, according to the theoretical state, the mother roll is hoisted on the aging frame, according to the electricity The target of the inner picking target of the halo is placed on the slitting machine shelf, and the steel core is clamped with the restraint button, leaving the steel core support arm and driving.

Release: When there is no film on the slitter, release film must be held. Exercising the stripping device and function button of the slitting machine, one end of the original membrane is attached to the eye of the stripping chain, and the button of the stripping is activated to spread the film along the slitting process to spread flat on each roller.

Film: When there is a film on the slitter, when the paper is changed, the vacuum filming station is used to start the filming station to the working position. The film on the first traction roller of the slitting machine is flattened and the upper vacuum pumping membrane is actuated, so that the film is flatly adsorbed on the filming table, the single-sided tape is attached and the excess film under the tape is cut off, and the film is placed on the shelf. The film is flattened and the lower vacuum pump is activated to make the film flat and flat. The paper layer on the tape is removed and the adhesive film is flattened. The discussion is neat and wrinkle-free. Then the low vacuum pump is turned off and the filming station is opened to the inoperative position.