The power of the slitter is a comprehensive concept. In the cutting process, the stable tension system of the automatic slitting machine is a main target to ensure the quality of the product. The magnetic powder clutch and brake are a special active actuator. The automatic slitting machine is filled in the mission gap or The film is cut into moments, and the magnetizing current can be modified to change the magnetic state of the magnetic powder, thereby adjusting the transmitted torque. It can be used for stepless speed regulation from zero initial to synchronous speed. It is suitable for high speed section fine adjustment and medium and small power speed regulation system. The automatic slitting machine controls the tension between the unwinding, pulling, slitting and winding, so that the slitting data is always in a fluctuating state during the slitting process.

     Assuming the tension control is stable, the automatic slitting machine can prevent the original data from being deformed and drifted during the process of speeding up and slowing down the machine. The meeting will create the sum of the troubles of the next process and the tension of the reel. Automatic slitting machine Most of the previous slitting machines use magnetic powder clutch to control the tension, but the magnetic powder clutch speed can not be high. The automatic slitting machine is easy to form the high-speed conflict of magnetic powder during operation, and the automatic slitting machine is now mostly used. The sagittal variable frequency motor is used to control the tension system of the slitting machine. The active detection of the pendulum roller is adopted. The human machine is used for low temperature, and the automatic slitting machine shortens its life. When it is severe, it will be stuck and the machine will be blocked.

     Following the development of technology, servo drive skills and other components. It is the cutting of raw materials into a number of independent units, the mission principle is to fix the raw materials on the discharge, put One end of the material shaft is equipped with a magnetic powder tension controller to stabilize the tension required for the raw materials, and then a pair of rubber rollers are used to pull the raw materials. The fully automatic slitting machine is cut into several pieces by the blade, and then guided to the A by the guide rollers. B receives the reel and stops the winding product.