You understandHow to operate the slitter settings?   Today, Hengguang Machinery Xiaobian will come to you for the popular science, if you are interested, let's take a look!

  Open the electrical isolation switch (set in front of the electric control cabinet), press the EMERCENCYSTOPRESET and READYTORUN buttons, the key Turn on MACHINE to RUN (on the main console) to check the voltage (380V), whether the current is correct and stable. Open the hydraulic system power switch (set on the main hydraulic drive frame), check that the main hydraulic drive system oil level and pressure gauge display is correct and stable.  

  Open the pneumatic shutoff valve (set on the intake pipe under the pneumatic control cabinet), check if the air pressure is correct (not Less than 6.0 bar), stable. Set the slitting menu according to the type, thickness, length, width, etc. of the film arranged in the slitting plan.  

  From the PDF, file the corresponding BOPP film file. Set the winding length and width of the film of the corresponding specification. Select the corresponding winding station, adjust the pressure roller arm and pressure roller, and install the paper core of the corresponding specification.  

  Loading: According to the requirements of the cutting plan, according to the driving procedures, according to the actual situation, hoist the corresponding on the aging rack The mother roll is placed on the slitting machine unwinding frame according to the inner and outer selection direction of the corona surface, and the steel core is clamped by the control button, leaving the steel core support arm and driving.  

  Filming: When there is no film on the slitting machine, it must be filmed. Using the slitting machine through the membrane device and the function keys, one end of the original membrane is attached to the membrane chain eyelet, and the membrane button is activated to distribute the membrane along the slitting process to be evenly distributed on each roller.  

  Film: When there is a film on the slitting machine, when using the vacuum film First, the filming station is first started to the working position, the film on the first pulling roller of the slitting machine is manually flattened and the upper vacuum pumping film is actuated, so that the film is flatly adsorbed on the filming platform, and double-sided tape is attached. Cut off the excess film under the tape, flatten the film on the unwinding frame and start the lower vacuum pump to flatten the film. Remove the paper layer on the tape and flatten the adhesive film. The joints should be neat, wrinkle-free, and then turn off. The vacuum pump opens the film station to the inoperative position.

  You Zheng Hengguang Machinery as a professional Checker, Rewinding Inspection Machine , winding machine< pan="">Manufacturers, dedicated to provide you with quality service, welcome to call!