< p="">The slitting machine is in the process of work, especially after quick use. If some of the workpieces are not repaired in time, if the smoothing is not enough, the friction will occur, which will lead to the board stagnation in the long run. Deviations such as damage or paper jams can occur. Therefore, it is often necessary to maintain slitting machine

< p=""> Therefore, some friction parts of the nonwoven slitter must be properly smoothed and maintained. In addition to the smoothing machine, the following inspections and asylum work must be carried out every week: inspection of the thickness of the non-woven slitter brake disc. Adjust them as they wear out. Inspection of non-woven slitter linear guides is not clean and clean if necessary.

Inspection of the non-woven slitter drive belt is not to maintain proper tension. The atmosphere pipeline for inspecting the non-woven slitting machine is not revealed by the atmosphere, the atmosphere filter is not clean, and the filter element is cleaned at least once a month. Inspect the middle of the rubber roller of the non-woven slitting machine. Please be delicate, they are not hard materials, and there is no such thing as a cutting tool.

Use 1 liter of cleaning solution per week (warm water with low-profile soap or solvent, wait for the solution to dry faster) and wipe the roller with a lint-free cloth. Inspect the atmosphere filter fan filter of the non-woven slitter. If there is too much dust, please adjust it. When the non-woven slitting roller becomes dirty, it may be scrubbed with fine gauze and property alcohol, but it is not necessary to rub the black part with alcohol to avoid rust.

The inspection and shelter of the non-woven slitter are basically the same. In addition, if the board lag rate is never utilized, the board must be cleaned and coated with anti-rust oil, and a plastic sleeve must be used. The stagnation is masked. If the board is not suspended for 3 months, a layer of moisture-proof paper should be applied to the anti-rust oil.